ViewSonic Q9b-1 Uživatelský manuál stáhnout pdf (Strana 2)

Steps

1. Remove the plastic shielding on the back of the monitor that covers the screwed

holding on the stand. This should come off easily by squeezing it, but sometimes

a flathead screwdriver is necessary to press the tabs to release the shielding.

2. Using the Phillips head screwdriver, remove the 8 screws holding the stand to

the monitor. The 2 screws in the lower corners are much longer than the other

screws. Remember these must go back in the same spot later. They are circled

below.

3. Using the flathead screwdriver, or the plastic wedge, separate the outer plastic

casing of the monitor. There are inner tabs going around the entire monitor that

must be released. The screwdriver is generally more effective for releasing the

tabs, but a plastic wedge should be used if you are concerned about the

cosmetic look of the monitor.

1 2 3 4 5 6 7 8 9

Žádné komentáře

ViewSonic Q9b-1 Uživatelský manuál Strana 2