ViewSonic 10pro Uživatelská příručka stáhnout pdf (Strana 13)

Touch Panel Setup

The touch panel of this device has been factory calibrated. In most cases,

recalibration is not necessary. However, due to the nature of capacitive touch panel,

change of geographical location may require recalibration for the new environment

conditions.

If touch panel is experiencing improper behavior, please perform touch panel

calibration procedure as below.

1. Tap on (ILITEK) icon to open touch panel calibration menu.

Fig. 2-9 Touch Panel Calibration Menu

2. Place the device on a at table top. Avoid any touch contact to the touch panel

while performing the calibration.

3. Tap on “Calibration” to start the process.

4. When calibration is completed, message “Calibration OK” will be shown.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Žádné komentáře

ViewSonic 10pro Uživatelská příručka Strana 13